After OEM EIR SPC Vinyl Flooring is installed, it sometimes appears soft. When you step on the floor with your foot, the floor trembles up and down, and it feels very uncomfortable. When the floor is shaking up and down, if the floor is not glued, the male tenon and the female tenon of the floor rub against each other to produce noise. Therefore, it is very necessary to analyze the cause of the problem and take preventive measures.

1. Softness caused by uneven ground

Due to the unevenness of the ground, just after the floor is installed, walking on the floor will feel that the floor is soft, and sometimes there will be noises, and there are not many noises.

2. Insufficient clearance for installation

The moisture content of OEM EIR SPC Vinyl Flooring is relatively low when it leaves the factory. The moisture content of most floors is below 5%. After installation, the floor absorbs moisture and expands. Some of them are because the ground is not well protected from moisture, and a large amount of ground water enters the floor.

3. Local expansion

During the use of OEM EIR SPC Vinyl Flooring, due to the partial ventilation of the moisture-proof film, the floor will locally swell after being partially damp, but the adjacent area of the floor is not damp, nor swelled, and local bulging will occur.